#USB ISOLATOR SCHEMATIC SERIAL#
#USB ISOLATOR SCHEMATIC FULL#

The bus voltage also drives an ADuM5000, which is used to create a VBUS2 voltage for the downstream side of the ADuM4160 with up to 100 mA of power for the peripheral. Power for the upstream USB connector is derived from the 5 V VBUS voltage available on the USB cable. However, it is a custom application that is not completely compliant with the USB standard. What can be achieved is a fixed speed or switch-controlled speed cable that can supply a modest power to the downstream peripheral. This is all in addition to the speed detection limitations of the ADuM4160.

In addition, the quiescent current of the converter does not comply with the standby current requirements of the USB standard. It is not possible to make a fully compliant bus-powered cable because there are no 100% efficient power converters to transfer the bus voltage across the barrier. The goal of the application circuit shown in Figure 1 is to isolate a peripheral device that already implements a USB interface.

Supports isolated power delivery through the cable.

#USB ISOLATOR SCHEMATIC FULL#

Supports full speed or low speed signaling rates.Implements an automatic scheme for data flow of control that does not require external control lines.Directly isolates, in the upstream, the USB D+ and D− lines of a cable.As with isolating any device, the services that the ADuM4160 provides are as follows: The challenge that must be met is to use this to create a bus-powered cable isolator by pairing the ADuM4160 with a small isolated dc-to-dc converter such as the ADuM5000. The ADuM4160 provides an inexpensive and easy way to implement an isolation buffer for medical and industrial peripherals. The hub chip can be eliminated, and the design becomes very small and simple. However, in many cases, while it is not certifiable as fully USB compliant, a single speed cable is acceptable from a practical standpoint, especially if custom connectors are used so that it cannot be confused with a compliant device. The upstream side of a hub controller can be thought of as a standard fixed speed peripheral port that can be easily isolated with the ADuM4160, whereas the downstream ports are all handled by the hub controller. The best way to address this is to combine the ADuM4160 with a hub controller. The ADuM4160 is intended to be hardwired to a single speed via pins therefore, it works when the peripheral plugged into its downstream side is the correct speed, but it fails when the wrong speed peripheral is attached. Unlike the case of building a dedicated peripheral interface where the speed is known and not changed, host applications must adapt to detect whether a low or full speed device has been connected. The upstream connection must act like a peripheral, and the downstream connection must behave like a host. Whereas the buffers on the upstream and downstream sides of the ADuM4160 are the same and capable of driving a USB cable, the downstream buffers must be capable of adjusting speed to a full or low speed peripheral that is connected to it. Several issues must be addressed to use the ADuM4160 for this application.

However, there are occasions when it is useful to create an isolated cable function. The ADuM4160 is designed primarily as an isolation element for a peripheral USB device. There has been a strong desire on the part of industrial and medical equipment manufacturers to use the bus as well, but adoption has been slow because there has not been a good way to provide the isolation required for connections to machines that control dangerous voltages or low leakage defibrillation proof connections in medical applications. It is displacing RS-232 and the parallel printer port because of superior speed flexibility and support of device hot swap.

#USB ISOLATOR SCHEMATIC SERIAL#

The universal serial bus (USB) is rapidly becoming the standard interface for most PC peripherals.

Usb isolator schematic